vialroom
Thread · #reconstitution · 2025-11-08

a 3ml syringe for the diluent and a u100

Spun off from a message in #reconstitution on 2025-11-08. 14 messages, 5 participants.

The message this came from
  • triumph_watch — a 3ml syringe for the diluent and a u100 for the dose is the setup most people here end up with 13:39
HH

30mg in 3ml is 10mg/ml, so 5mg is 50 units. half the barrel, feels like a lot but its right

TW

aim the diluent at the glass wall, not at the powder. it goes in gentler

AA

temperature of the diluent does not matter. how fast you push it in does

TW

the jewellery scale is a good habit but calibrate it, they drift badly

AA

5mg in 2ml gives 2.5mg/ml, 0.25mg is 10 units. good for a starting dose

SD

i keep a spare vial of bac water in the fridge purely so i never rush the maths

🔥3
AA

if you cannot read the mark confidently, your volume is too small. redo it at a lower concentration

HH

if you draw up with a bigger pin and inject with a fresh one you lose a bit more to dead space

💀2🙏9
EE

benzyl alcohol is what makes it bacteriostatic. it is about 0.9% typically

💀1