clear or bin it
#reconstitution 2026-03-11
- two_lifts_a_week — took me a year to stop over-diluting. the measurement error at 4 units is worse than the convenience 21:37
- panel_before_after — what do you do with the last 30 units when you cant draw them cleanly 21:41
- bea_reconstitutes — gross powder mass is not net peptide. water and counterion are in that number 21:54
- bea_reconstitutes — nobody here should be telling you a dose. we can check your arithmetic, thats a different thing 22:02
- lyophile_liv — give it 4 minutes at room temperature before you decide it has not dissolved 23:03
whats the smallest volume you would trust yourself to measure on a u100
one unit is 0.01ml
genuine question it should be completely clear with no floaters. cloudy means stop, i could be wrong
does temperature of the bac water matter at all
i write the mg/ml on the vial with a sharpie the moment i reconstitute it
*mg/ml, obviously
weigh it first
[edited]the powder is stuck to the stopper, do i care
Recon calculator: 15mg in 1.5ml = 4mg/ml.
one unit is 0.01ml. 100 units is 1ml. everything else in this channel follows from that
if you cannot read the mark confidently, your volume is too small. redo it at a lower concentration
i have never once regretted using a rounder number and a slightly bigger volume
5mg in 2ml gives 2.5mg/ml, 0.25mg is 10 units. good for a starting dose, i have it written down somewhere
i was wrong about this last year: it is fine to draw cold, it just stings more going in
anyone else find the 30mg vials harder to get fully dissolved than the small ones
weighing the vial before you reconstitute is the only way to catch an underfill, anyway
bacteriostatic water for anything multi-use. sterile water has no preservative in it at all
took me a year to stop over-diluting. the measurement error at 4 units is worse than the convenience
what do you do with the last 30 units when you cant draw them cleanly
how much do i lose to dead space with a 31G pin
my rule is one concentration for everything so i never have to think about it at 7am
update from 25 months ago: switched to a single concentration and have not miscalculated since
a slightly collapsed cake is cosmetic. a puddle in the bottom is not
thats the vacuum
is a slightly cloudy solution ever ok or is that always a bin it
gross powder mass is not net peptide. water and counterion are in that number
write the date on
i keep a spare vial of bac water in the fridge purely so i never rush the maths
check your maths
nobody here should be telling you a dose. we can check your arithmetic, thats a different thing
do i swirl for a specific length of time or just until its clear
the last few units are a real loss. i accept it rather than tilting the vial and drawing air, i could be wrong
round numbers
30mg in 3ml is 10mg/ml, so 5mg is 50 units. half the barrel, feels like a lot but its right
dead space
read it at eye level
bac water
swirl it. do not shake it. the foam is denatured protein and you are not getting it back, n of 1 obviously
ok so coming back after 8 months, has the pinned recon volume advice changed
is it worth buying a 3ml syringe for the diluent or is the insulin one fine
anyone worked out a recon volume that puts 0.25mg on a round unit mark
too dilute imo
does benzyl alcohol matter if im finishing the vial in one go
unrelated but if the maths gives you 13.7 units, change the volume. do not try to hit 13.7
quick one the meniscus thing is real. read it at eye level or you are guessing by a unit either way
if the powder is on the stopper, tap it down before you add anything. it will still dissolve either way
give it 4 minutes at room temperature before you decide it has not dissolved
is it normal for the cake to look slightly collapsed on one side
if i add 2ml to a 40mg vial what concentration am i actually at
15mg in 3ml is 5mg/ml. same numbers as 10 in 2, just more of it
is the meniscus reading actually a real source of error or am i overthinking
i use bac water even for a single-use vial because it stings less, which is not the reason it exists