vialroom

#reconstitution 2025-11-09

Sunday31 messages8 participantstimes are UTC
Highlights from this day
  • luerlok — gross powder mass is not net peptide. water and counterion are in that number 20:11
  • chlorhex — you can absolutely just always use 2ml, and honestly most of us should if you draw up with a bigger pin and inject with a fresh one you lose a bit more to dead space 21:35
  • chlorhex — i keep a spare vial of bac water in the fridge purely so i never rush the maths 21:36
CH

20mg in 2ml is 10mg/ml. 1mg is 10 units, 2mg is 20 units, easy

the vacuum will pull it in. let it. fighting it is how you get a face full of aerosol

do you let it come to room temp before drawing or draw it cold

gross powder mass is not net peptide. water and counterion are in that number

[edited]
💀4
LU

if you cannot read the mark confidently, your volume is too small. redo it at a lower concentration

i was wrong about this last year: it is fine to draw cold, it just stings more going in

thats fine

6
WW

took me a year to stop over-diluting. the measurement error at 4 units is worse than the convenience
the meniscus thing is real. read it at eye level or you are guessing by a unit either way

write the date on

i use bac water even for a single-use vial because it stings less, which is not the reason it exists

quick one is there any reason not to just always use 2ml

FT

pick the volume so your dose is a whole number of units. thats the entire trick

i have never once regretted using a rounder number and a slightly bigger volume

CH

you can absolutely just always use 2ml, and honestly most of us should
if you draw up with a bigger pin and inject with a fresh one you lose a bit more to dead space

📉1

i keep a spare vial of bac water in the fridge purely so i never rush the maths

15📈1

is the meniscus reading actually a real source of error or am i overthinking

DD

do not add more bac water to an already reconstituted vial, you have lost track of the concentration