nope, redo it
#reconstitution 2025-10-23
- VialBot — Purity check: no report on file for lot H-2814. Nothing logged either way. 13:45
- cold_chain_cmdr — if you cannot read the mark confidently, your volume is too small. redo it at a lower concentration 16:11
- power_cut_pia — if you draw up with a bigger pin and inject with a fresh one you lose a bit more to dead space, someone check my working 16:30
- sulphur_burp — a 3ml syringe for the diluent and a u100 for the dose is the setup most people here end up with 19:17
does temperature of the bac water matter at all
Purity check: no report on file for lot H-2814. Nothing logged either way.
ok so 30mg in 3ml is 10mg/ml, so 5mg is 50 units. half the barrel, feels like a lot but its right, we shall see
the meniscus thing is real. read it at eye level or you are guessing by a unit either way
my 10mg vial weighed 11.4g on the jewellery scale, is that wrong
you can absolutely just always use 2ml, and honestly most of us should
write the date on
lyophilised powder is far more robust than people think. it is the solution that is fragile
i was wrong about this last year: it is fine to draw cold, it just stings more going in
is it normal for the cake to look slightly collapsed on one side
read it at eye level
can i add more bac water later to a vial ive already reconstituted
does benzyl alcohol matter if im finishing the vial in one go
if you cannot read the mark confidently, your volume is too small. redo it at a lower concentration
genuine question if the maths gives you 13.7 units, change the volume. do not try to hit 13.7
how much do i lose to dead space with a 29G pin
yep 10 units
clear or bin it
if you draw up with a bigger pin and inject with a fresh one you lose a bit more to dead space, someone check my working
swirl dont shake
a 3ml syringe for the diluent and a u100 for the dose is the setup most people here end up with