label the date too. you will not remember which vial is which by week 6, still working it out
#reconstitution 2025-11-06
- verify_or_dont — right so one unit is 0.01ml. 100 units is 1ml. everything else in this channel follows from that 19:34
- quiet_head_qi — if you draw up with a bigger pin and inject with a fresh one you lose a bit more to dead space 20:40
- ida_injects — coming back to this the vacuum will pull it in. let it. fighting it is how you get a face full of aerosol 21:02
- ida_injects — the powder is stuck to the stopper, do i care 21:20
- quiet_head_qi — update on the earlier thing im getting bubbles in the barrel every single time, what am i doing wrong 21:43
aim the diluent at the glass wall, not at the powder. it goes in gentler
read it at eye level
right so one unit is 0.01ml. 100 units is 1ml. everything else in this channel follows from that
why does everyone say 2ml specifically and not 1ml
took me a year to stop over-diluting. the measurement error at 4 units is worse than the convenience
i write the mg/ml on the vial with a sharpie the moment i reconstitute it
5mg in 2ml gives 2.5mg/ml, 0.25mg is 10 units. good for a starting dose
lyophilised powder is far more robust than people think. it is the solution that is fragile
if you draw up with a bigger pin and inject with a fresh one you lose a bit more to dead space
coming back to this the vacuum will pull it in. let it. fighting it is how you get a face full of aerosol
the last few units are a real loss. i accept it rather than tilting the vial and drawing air
the powder is stuck to the stopper, do i care
10mg vial
+ 1.0ml -> 10.0 mg/ml 0.5mg = 5u 1mg = 10u
+ 2.0ml -> 5.0 mg/ml 0.5mg = 10u 1mg = 20u
+ 2.5ml -> 4.0 mg/ml 0.5mg = 12.5u (dont)
+ 5.0ml -> 2.0 mg/ml 0.5mg = 25u 1mg = 50uhow much do i lose to dead space with a 30G pin
quick one does benzyl alcohol matter if im finishing the vial in one go
update from 6 months ago: switched to a single concentration and have not miscalculated since
update on the earlier thing im getting bubbles in the barrel every single time, what am i doing wrong
not sterile water
weighing the vial before you reconstitute is the only way to catch an underfill