for the archive 15mg in 3ml is 5mg/ml. same numbers as 10 in 2, just more of it
👀2
#reconstitution 2025-09-14
Sunday15 messages5 participantstimes are UTC
Highlights from this day
- forty_units — for the archive 15mg in 3ml is 5mg/ml. same numbers as 10 in 2, just more of it 19:16
- lyophile_liv — if you cannot read the mark confidently, your volume is too small. redo it at a lower concentration 20:16
- tga_notice — ok so if the powder is on the stopper, tap it down before you add anything. it will still dissolve either way 20:22
- two_ml_two — i use bac water even for a single-use vial because it stings less, which is not the reason it exists 21:21
coming back to this do you let it come to room temp before drawing or draw it cold
im getting bubbles in the barrel every single time, what am i doing wrong
if you cannot read the mark confidently, your volume is too small. redo it at a lower concentration
do i swirl for a specific length of time or just until its clear
not sterile water
bac water
ok so if the powder is on the stopper, tap it down before you add anything. it will still dissolve either way
pick the volume so your dose is a whole number of units. thats the entire trick
bacteriostatic water for anything multi-use. sterile water has no preservative in it at all
anyone else find the 15mg vials harder to get fully dissolved than the small ones
check your maths
❤️2👀4
coming back to this 5mg in 2ml gives 2.5mg/ml, 0.25mg is 10 units. good for a starting dose
i use bac water even for a single-use vial because it stings less, which is not the reason it exists
weigh it first