unrelated but one unit is 0.01ml. 100 units is 1ml. everything else in this channel follows from that
#reconstitution 2025-04-04
Friday18 messages5 participantstimes are UTC
Highlights from this day
- lean_mass_lex — unrelated but one unit is 0.01ml. 100 units is 1ml. everything else in this channel follows from that 18:48
- lean_mass_lex — if the powder is on the stopper, tap it down before you add anything. it will still dissolve either way 18:50
- lead_time_lars — 15mg in 3ml is 5mg/ml. same numbers as 10 in 2, just more of it 21:01
label the vial
if the powder is on the stopper, tap it down before you add anything. it will still dissolve either way
it should be completely clear with no floaters. cloudy means stop
round numbers
⚠️6
weighing the vial before you reconstitute is the only way to catch an underfill, not advice obviously
thats the vacuum
clear or bin it
[redacted at member request] · archive policy
is there any reason not to just always use 2ml
5mg in 2ml gives 2.5mg/ml, 0.25mg is 10 units. good for a starting dose
whats the smallest volume you would trust yourself to measure on a u100
10mg in 2ml is 5mg/ml. so 0.5mg is 0.1ml which is 10 units on a u100
it foamed. is it ruined
is it normal for the cake to look slightly collapsed on one side
if you cannot read the mark confidently, your volume is too small. redo it at a lower concentration
15mg in 3ml is 5mg/ml. same numbers as 10 in 2, just more of it
🧊7
ok so aim the diluent at the glass wall, not at the powder. it goes in gentler