do i swirl for a specific length of time or just until its clear
#reconstitution 2025-01-27
- LC_MS_Lena — foam is air being whipped into a protein solution. the air-water interface is where peptide unfolds 20:37
- coa_or_cope — not straight into the cake like a fire hose 21:09
- LC_MS_Lena — then either it was not sealed properly or somebody already opened it. worth noticing, not worth panicking about 22:04
- coa_or_cope — clear with nothing floating is what you want. if it is still cloudy after five minutes of gentle work, stop and ask 22:10
- LC_MS_Lena — for what it is worth i have never had someone send me a foamed vial that assayed low. i also do not get sent many, so that means very little 23:04
New independent result logged — WXT, lot E-2205, purity 96.8% (Medutest).
the last few units are a real loss. i accept it rather than tilting the vial and drawing air
anyone got a photo of what a properly dissolved vial looks like
does it matter if i inject the bac water straight at the powder
benzyl alcohol is what makes it bacteriostatic. it is about 0.9% typically, someone check my working
how long after reconstituting before its actually dissolved
mine foamed. did i kill it
did you shake it
i shook it like a cocktail. yes.
there is your foam
foam is air being whipped into a protein solution. the air-water interface is where peptide unfolds
one shake is not automatically a dead vial. it is not free either
so swirl
swirl, or roll it between your palms. sometimes it takes a couple of minutes and that is normal
stick it back in the fridge for ten minutes and most of the foam collapses on its own
the foam collapsing does not undo anything. it just makes it invisible
how do you get the water in without splashing it about
aim the needle at the glass wall above the powder cake and let it run down the side
not straight into the cake like a fire hose
the other thing is the vacuum. most lyophilised vials sit under a bit of negative pressure
it will pull the plunger down on its own if you let it. keep a thumb on it
mine took the whole 2ml in by itself
that is a good sign actually. it means the stopper seal held in transit
and if there is no vacuum at all?
then either it was not sealed properly or somebody already opened it. worth noticing, not worth panicking about
cake dissolved in about 40 seconds of rolling. clear, no bits
clear with nothing floating is what you want. if it is still cloudy after five minutes of gentle work, stop and ask
for what it is worth i have never had someone send me a foamed vial that assayed low. i also do not get sent many, so that means very little
who sends you vials, out of interest
i do analytical work. not for a vendor. people send me things and i tell them what is in them
cheers both