swirl it. do not shake it. the foam is denatured protein and you are not getting it back
#reconstitution 2024-11-12
- VialBot — New independent result logged — ERP, lot D-0718, purity 99.2% (VendorInvestigate). 13:56
- swirl_not_shake — gross powder mass is not net peptide. water and counterion are in that number bacteriostatic water for anything multi-use. sterile water has no preservative in it at… 14:34
- swirl_not_shake — my rule is one concentration for everything so i never have to think about it at 7am 15:23
right so it should be completely clear with no floaters. cloudy means stop
read it at eye level
New independent result logged — ERP, lot D-0718, purity 99.2% (VendorInvestigate).
quick one i swirl for about thirty seconds and then leave it. never had one fail to dissolve
genuine question the meniscus thing is real. read it at eye level or you are guessing by a unit either way
not sterile water
round numbers
update on the earlier thing what do you do with the last 30 units when you cant draw them cleanly
dead space
gross powder mass is not net peptide. water and counterion are in that number
bacteriostatic water for anything multi-use. sterile water has no preservative in it at all
the powder is stuck to the stopper, do i care
aim the diluent at the glass wall, not at the powder. it goes in gentler
how much do i lose to dead space with a 31G pin
anyone got a photo of what a properly dissolved vial looks like
[edited]my rule is one concentration for everything so i never have to think about it at 7am
if you draw up with a bigger pin and inject with a fresh one you lose a bit more to dead space, i have it written down somewhere
30mg in 3ml is 10mg/ml, so 5mg is 50 units. half the barrel, feels like a lot but its right
if the powder is on the stopper, tap it down before you add anything. it will still dissolve either way
label the vial
follow up if the maths gives you 13.7 units, change the volume. do not try to hit 13.7
it should be completely clear with no floaters. cloudy means stop
a 3ml syringe for the diluent and a u100 for the dose is the setup most people here end up with, we shall see
too dilute imo
if you cannot read the mark confidently, your volume is too small. redo it at a lower concentration
one unit is 0.01ml
the last few units are a real loss. i accept it rather than tilting the vial and drawing air
yep 10 units
nobody here should be telling you a dose. we can check your arithmetic, thats a different thing
swirl dont shake
15mg in 3ml is 5mg/ml. same numbers as 10 in 2, just more of it, we shall see
lyophilised powder is far more robust than people think. it is the solution that is fragile
update on the earlier thing label the date too. you will not remember which vial is which by week 32
weighing the vial before you reconstitute is the only way to catch an underfill
is it normal for the cake to look slightly collapsed on one side
i have never once regretted using a rounder number and a slightly bigger volume
follow up i keep a spare vial of bac water in the fridge purely so i never rush the maths
can i add more bac water later to a vial ive already reconstituted
is there any reason not to just always use 2ml